fvaz

true, they work like magic.

I had to simplify sharpening as much as possible and to find the most effective routine. I just wish diamond and cbn products would be...

I had good experience sharpening magnacut on a 2000 grit shapton glass Hr, tried sharpening at 3000 but havent felt much improvement...

I'm finally back in two wheels after a brief hiatus...... My car gets crap gas mileage and commuting to school is costing me a fortune...

I think you are right. Makes it even more unique. I love when the same happens to rosewood and snakewood.

Almost a year ago I received an order for a double high carbon stainless damascus gyuto, and while I've had some success making SS...

Well thank you! And I think that handle blank came from the edge of the board.

Just looked at the knife again and i was surprised to see that both sides of the handle have different patterns, that is SUPER cool. You...

I cannot ignore a knife out of such extraordinary material. As a maker, this is genuinely beautiful to see, needless to comment about...

You can tell the makers that ship a lot knives based on their packaging. Kippington, Spare's current style and Kamon all have top...

I know that. My comment was not to him specifically but his recommendation that buyers "make sure to ask if the maker has done...

No worries. It was a long day for me too. Found out the 3rd lead on a 3 position switch is not a ground the hard way. On the upside I...

Fair enough, especially because the steel can come in many states depending the supplier, which may require less or more processing

52100 is a good steel for swords, it can perform very similar to spring steels when doing it around 55~58hrc. Actually, 52100 is usually...

Hey guys, i have been away from forums and internet recently, mostly due the logistical inconveniences and problems i had dealing with...