Recent content by juniperburl

Table saw with a cross cut sled, and material clamped to sled so you can still have five fingers. Then sand flat with 220 on reference plate using figure 8 motion. If your sanding is sloppy, you'll get gaps. If you drill crooked holes you'll get gaps. If you can't cut square you get gaps...

Hey guys. I see this lingo getting tossed around a lot and sometimes used interchangeably for saya and handle, but I want to give y'all an opportunity to set it strait. I say pants are the saya, shoes are handle, but what do you think? Why? What other knife specific slang do you love?

Its all good! Don't feel embarrassed, I put you on the spot :p. Name change because I am just poking around, not promoting. The handle on the miz honyaki from carbon knife co is one from Joe I believe;). I'm sure your will turn out fine:).

Happy you like the design enough to to emulate it. That's one of mine, and it has always been one of my favorite designs. Lots of cool tones that do work well with kurouchi. Cheers, Cody

Aye aye capt.

Love these designs, especially that buckeyeburl/bog oak on the Denka. What inspired this design?

Hello gents, ladys, Ok, so I've finally succumbed to signing up. I just want to look at certain member only discussions (cough classifieds). You know, for fun. Who knows, might even get the nerve to engage you helpless bastards in discussion. Love, Cody @thegingerninja.abq