Help Support Kitchen Knife Forums:
-
-
KasumiJLA replied to the thread Honyaki restoration project - Going to document my journey.Fifth update : the marathon continues after 16 hours! The project is progressing slowly, but very well! I told myself to take my time... -
-
KasumiJLA reacted to jedy617's post in the thread Ashi Honyaki passaround - 165mm Kamagata (santoku) with
Like.
Less than 5 minutes total on a chosera 3k followed up by Nakayama suita and this thing is razor sharp. Very pleasant on the stones -
KasumiJLA reacted to thebradleycrew's post in the thread Ashi Honyaki passaround - 165mm Kamagata (santoku) with Like.
One thing you touched on that I agree with and I've have noticed a lot: softer wood and rubber boards (Hinoki, Hagesawa, etc.) tend to...
-
KasumiJLA reacted to Heckel7302's post in the thread Ashi Honyaki passaround - 165mm Kamagata (santoku) with Like.
Some further thoughts on the knife Cutting feel is fantastic. True Sakai laser. In head-to-head comparison with my Takada 240...
-
Here's a little snack for you stone sharks out there. This was a find from last year - it's a harder shale, but the particles are very...
-
It requires quite a bit of grinding to fit the tang into a wa handle. The Vnox tang is short and very wide. I used a dremel with a...
-
-
KasumiJLA reacted to Ok__mode_6953's post in the thread Thinning and polishing: What did I do wrong? What did I do right? A feedback thread. with Like.
Yeah I thought it was strange too! I was using a reasonable amount of pressure, but did most of the work on the 1k, and wasn’t at it...
-
KasumiJLA replied to the thread Thinning and polishing: What did I do wrong? What did I do right? A feedback thread..That was my thought too! I never saw a cladding that thin to be shown off only by removing low spots? @Ok__mode_6953 I think you did a...
-
KasumiJLA replied to the thread Show your work! Uchigumori and co....Clean, nice contrast and elegant: I like it! 👌
-
The classic takamura r2, kasumi version
-
KasumiJLA reacted to tostadas's post in the thread Fast thinning behind the edge with a rotary tool/dremel with Like.
You are far braver than me if you're willing to thin with a dremel. If it slips and the edge of the grind wheel scuffs the blade, the...
-
Got a new pretty Iromono in a fitted Dai this week.
-
The Kemadi bulat gyuto that I recently bought came a bit thick at/behind the edge (~.3mm - .4mm at 1mm behind the edge) compared to my...
-
Swapped out the handle, polished the spine and choil, and touched up Munetoshi on a Suita
-
-
Loading…
-
Loading…
