This is a 180mm magnacut nakiri. I would say its laser thin. I dont have an hrc tester yet but i would say based on the ht protocol i used the steel should be on the upper end of hardness for magnacut.
The handle is texas ebony, white g10 spacer, and resin filled zebra bone. The zebra bone had some thin cracks in the outside when i got it. So i filled those in with this "gold fill" stuff i have. I cant get it to show up well im the pictures. But basically its like a few gold (its brass) lines running through it.
Im asking $400 shipped for this. I wanted to ask at least 450. But the one main thing that has me taking off 50 dollars. Is the belts i had to finish on left some little dots on it you can see in certain light. Normally i could just go up in grit and they would be gone. But i dont have the money to buy higher grit scotch brite belts right now. So unfortunately I will have to see it as is.
Oh. I should add. I did grind this with a right hand bias though it should work fine for a lefty.
The handle is texas ebony, white g10 spacer, and resin filled zebra bone. The zebra bone had some thin cracks in the outside when i got it. So i filled those in with this "gold fill" stuff i have. I cant get it to show up well im the pictures. But basically its like a few gold (its brass) lines running through it.
Im asking $400 shipped for this. I wanted to ask at least 450. But the one main thing that has me taking off 50 dollars. Is the belts i had to finish on left some little dots on it you can see in certain light. Normally i could just go up in grit and they would be gone. But i dont have the money to buy higher grit scotch brite belts right now. So unfortunately I will have to see it as is.
Oh. I should add. I did grind this with a right hand bias though it should work fine for a lefty.
Last edited:
