Hello All,
I don't usually make stainless sujihiki, but I had a strip of a sheet left that was just the right size so I put it to good use.
Thanks for taking a look!
I don't usually make stainless sujihiki, but I had a strip of a sheet left that was just the right size so I put it to good use.
- Blade: 272mmx40mm AEB-L (63 hrc) scotchbrite belt finish
- Neck: 15mmx18mm
- Handle: 132mm long, bocote + walnut, oiled and waxed
- POB: 38mm from the hande
- Spine: 2.5mm at the neck, 2.2mm at 14.2cm, .57mm 1cm from the tip
- Grind: flat to convex, right hand bias
- Weight: 150g
- Relieved choil and spine
- Edge: .18mm@1mm, Measured at the midpoint.
Thanks for taking a look!
Attachments
Last edited: