Hello All,
This knife was a custom, but for reasons relating to the easy at which a stainless clad blade takes a set, as well as some crookedness in the spine (see attached, the edge is straight however), the owner elected to return it for a blade clad with 15n20 in its place. Now that, that blade is complete, I'm listing this one here.
Thanks for looking!
This knife was a custom, but for reasons relating to the easy at which a stainless clad blade takes a set, as well as some crookedness in the spine (see attached, the edge is straight however), the owner elected to return it for a blade clad with 15n20 in its place. Now that, that blade is complete, I'm listing this one here.
- Blade: 279mmx40mm 304ss clad Apex Ultra (67-68hrc) 600 grit finish+etch/polish
- Neck: 17mmx18mm
- Handle: 133mm long, 23mmx26mm tapering to 20mmx23mm, purple heart, oiled and waxed
- POB: 45mm from the hande
- Spine: 4.45mm at the neck, 3.9mm above the heel, 3.0mm at halfway, .79mm 1cm from the tip
- Grind: 50/50ish
- Weight: 211g
- Relieved choil and spine
- Edge: .21mm@1mm, .36mm@2mm, .67mm@5mm, 1.12mm@10mm Measured at the midpoint.
Thanks for looking!