It’s time to thin my vintage herd a little. Happy to give my KKF brethren first dibs before putting them up on eBay. All prices are inclusive of CONUS shipping, fees, and a fresh edge. Any questions, feel free to ask. If more than one is purchased I’ll take $10 off each additional knife. My first BST post, hope you enjoy!
Henckels Twinworks 102-10
Carbon Steel
Edge-224mm
Height-49mm
Weight-270g
Wood handle scales (walnut?)
$100
I did minimal work on this knife. It’s in pretty original condition, considering it’s age. It has asymmetrical geometry (flat on left side, convex on right). Bolster is ground down to the sharpening angle.
Profile appears near identical to new aside from my correcting a small hole in the edge in the back third of the blade road. Almost no height lost at heel, the chamfer at the bottom of the bolster is still visible.
Handle stamp still has some original silver coloring, it was sanded lightly and small gaps filled with beeswax. Really nice distal taper and tapered tang.
Sabatier Chef au Ritz 9” Chef
Carbon Steel
Edge-236mm
Height-45.8mm
Weight-232g
Hard Rubber handle scales
$80
Quite original condition. Just cleaned up the faces with flitz and put a new bevel on it.
Henckels Twinworks 102-10
Carbon Steel
Edge-224mm
Height-49mm
Weight-270g
Wood handle scales (walnut?)
$100
I did minimal work on this knife. It’s in pretty original condition, considering it’s age. It has asymmetrical geometry (flat on left side, convex on right). Bolster is ground down to the sharpening angle.
Profile appears near identical to new aside from my correcting a small hole in the edge in the back third of the blade road. Almost no height lost at heel, the chamfer at the bottom of the bolster is still visible.
Handle stamp still has some original silver coloring, it was sanded lightly and small gaps filled with beeswax. Really nice distal taper and tapered tang.
Sabatier Chef au Ritz 9” Chef
Carbon Steel
Edge-236mm
Height-45.8mm
Weight-232g
Hard Rubber handle scales
$80
Quite original condition. Just cleaned up the faces with flitz and put a new bevel on it.
Last edited: