apex ultra

Have tried a few nakiris and haven’t gelled with any, except a Shindo (which I wish was larger). Looking to try an Eddworks Nakiri with an s grind with minimum specs of 180mm x 65mm. Preference for AU but will consider AEBL and 52100. Not too hopeful, but no harm in asking!

Hello All, I'm not sure I've seen any low carbon clad Apex Ultra as of yet, so this blade might be a bit unique, perhaps not. It's a smaller piece of a march larger billet I rolled to get a sense of how thin I can roll my cores with my setup. The core on this blade measures .4mm thick, or...

Hello All, Here's a stainless clad Apex Ultra paing knife for your consideration. Nothing too fancy on this one, just performance oriented from the bottom up. Blade: 110mmx28mm belt finished Apex Ultra (67-68 hrc) stainless san-mai w/ nickel layer to prevent carbon migration Neck...

Hello All, 6/7 A nice stiff mono steel Apex Ultra sujihiki Blade: 280mmx34mm Apex Ultra (67-68hrc) scotchbrite belt finish Neck: 14mmx14mm Handle: 145mm long, 22mmx25mm tapering to 19mmx22mm, burned oak, oiled and waxed POB: 60mm from the hande Spine: 3.98mm at the neck, 2.98mm at...

Hello All, It feels like ages since I've made a new listing here. Here I have a nice gyuto to offer you all in Apex Ultra go-mai with a lovely bocote handle. I keep working to get my core thicknesses down as much as possible in san-mai and go-mai, little by little I'm getting better, I have...

Hello KKFers, Knife information (he took more and much better pictures than I can): https://en.messerschmiede-hangler.at/product-page/220-gyuto-gestockte-birke-apexultra-san-mai Knife is like new, as in I've cut a handful of veggies with it. Other than that, it has just sat in the box it came...

Hello All, With the latest batch of Apex Ultra out, I decided I'd finally get around to using up the stock I had on hand. This will be the first of 2 mono-steel gyutos and sujihiki I'm working on at the moment. The blade is fairly thick out of the spine, with very little taper occurring until...

Hi KKF, For sale I have a Birch and Bevel Apex Ultra. Made in collaboration by Isasmedjan and Tobias Hangler. I actually quite like this knife. It's an amazing all round and midweight. Plus its a cool new-ish steel and really nice handle. Really like the birch bark. Selling because I'm...

Hello All, This is my longest blade in a while. It's been finished out to 1200 grit, and given a light etch and polish with loose abrasive to better reveal the core against the cladding. Blade: 335mmx33mm Apex Ultra/15n20 san-mai ~67 HRC, 1200 grit finish Neck: 15mmx18mm Handle: 127mm...