WTS 270mm Wrought Iron+52100 San-Mai Sujihiki

Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

MSicardCutlery

Full-time Knifemaker-Canadian Mazaki
KKF Sponsor
Joined
Feb 28, 2022
Messages
2,264
Reaction score
6,674
Location
Canada
Hello All,

Here I have the second of two wrought clad sujihiki I made recently. This one came out as intended with a cladding line on the lower side, and excellent characteristics overall.


20230126_144437.jpg

20230126_144700.jpg

20230126_144606.jpg

20230126_144648.jpg

20230126_144511.jpg



  • Blade: 276mmx40mm wrought clad 52100 san-mai (~64 hrc),1200 grit finish, etch and polish
  • Neck: 14mmx18mm
  • Handle: 134mm long, 23mx25mm tapering to 19mmx22mm, Bloodwood and Peruvian Walnut, oil finished and waxed
  • POB: 45mm from the hande
  • Spine: 3.38mm at the handle, 3.08mm above the heel, 2.65mm at 13.5cm, .61mm 1cm from the tip
  • Grind: flat to convex, right hand bias
  • Weight: 171g
  • Relieved choil and spine
  • Edge: .16mm@1mm, .24mm@2mm, .54mm@5mm, .96mm@10mm Measured at the midpoint.
Asking $530 U.S + $25 U.S for shipping with insurance anywhere in North America. Overseas will be in the ballpark of $50-$75 U.S depending on the area.



Thanks for taking a look!
 
Thank you. And I don't know what the original source was, it came to me as a 1.75" diameter bar 2' long. But the wave pattern is from the forging with my drawing dies and the contrast is from carbon migration, as well as just different levels of carbon within the wrought itself.
 
Back
Top