WTS Tetsujin kasumi metal flow (almost)

[ahhactive]

Hello did a pimped up on my kasumi tetsujin used gently but did an overhaul on the looks. handle is a full mono ebony made by the great Ki Craftsman in Indonesia.$400 conus

Edge length: 233mm
Height at heel:50mm
Spine out of handle: 2.8mm
Weight:184g

The middle one

 

[JPAU]

Hello. What are its length, weight, heel height, spine thickness etc?

 

[ahhactive]

Hello. What are its length, weight, heel height, spine thickness etc?

i'll info on it tonight when i get home

 

[ahhactive]

Spec updated

 

[bowei]

Spec updated

Is that actual blade length or edge length? Thanks.

 

[ahhactive]

Is that actual blade length or edge length? Thanks.

oops ...edited

 

[ahhactive]

Bump

 

[ahhactive]

Bump and adjustment to pricing

 

[enrico]

I’d be a little weary calling it a metal flow just because you etched it. I could be wrong but the metal flow ones actually had higher activity going on in the cladding which showed a more pronounced etch.


Still a nice knife regardless. GLWS

 

[ahhactive]

I’d be a little weary calling it a metal flow just because you etched it. I could be wrong but the metal flow ones actually had higher activity going on in the cladding which showed a more pronounced etch.


Still a nice knife regardless. GLWS

There's some work done to get the grain out (lota of fingering) rather than "just"etching. But you made a good point. Listing has been edited

Also listing as kasumi at kasumi prices.

 

[ahhactive]

Also just realised my thread has changed to twtsujin kasumi metal flow.

It was "kasumi turned MF i meant metal flow"

 

[ahhactive]

Will take on reasonable offers

 

[jonasdaniel666]

Hello where is it shipped from?