Working on #4 right now and it's really kicking my ass.
Yeah I was living in a dream world. #4 was a failure. While drilling the extremely deep tang hole it must have gotten too hot and the epoxy failed at the ferrule joint. Sucks because I had that wood planned for this project for a few years. It was to go on my Gesshin Hide 210mm kamagata usuba. Going to have to be on the lookout for a new block. Kind of a shame but it's a learning process so I'm surprisingly not upset.
Sorry to hear that. Quite often you can just take the pieces apart again, clean them up and start over - wouldn't that work here?
Stefan
That's what I've been thinking. but I would need a jig saw too though.This is what we need:
http://www.bladeforums.com/forums/showthread.php/695049-Power-broach?p=7537995#post7537995
Stefan
Enter your email address to join: