Adagimp
Well-Known Member
- Joined
- May 9, 2011
- Messages
- 146
- Reaction score
- 0
Unfortunately I just don't cut nearly as much as I used to and these poor ladies haven't seen the board in almost a year now. Figured it was time to pass them on to someone who will use them.
Up first is a Mario Ingoglia custom that I had made back in 2012. $365 shipped in the lower 48
Weights and Measurements:
Steel = CPM154
Weight 228g
Overall Length 360mm
Blade Length 243mm (mirror polish)
Cutting Edge Length 230mm
Handle Length 117mm (Bog oak with G10 spacers)
Blade Height at Heel 48mm
Blade Height 30mm from tip 22mm
Spine Thickness at Handle - ~2.75mm
Spine Thickness 30mm from Tip - ~1mm
Thickness ½ between spine and edge - ~2mm
Up first is a Mario Ingoglia custom that I had made back in 2012. $365 shipped in the lower 48
Weights and Measurements:
Steel = CPM154
Weight 228g
Overall Length 360mm
Blade Length 243mm (mirror polish)
Cutting Edge Length 230mm
Handle Length 117mm (Bog oak with G10 spacers)
Blade Height at Heel 48mm
Blade Height 30mm from tip 22mm
Spine Thickness at Handle - ~2.75mm
Spine Thickness 30mm from Tip - ~1mm
Thickness ½ between spine and edge - ~2mm