Some photos of my Akifusa being fixed:
Anout 6mm broken off tip:
View attachment 45041
A close up:
View attachment 45042
Spine ground down to meet the edge:
View attachment 45043
Rounding the spine out:
View attachment 45044
View attachment 45045View attachment 45046View attachment 45047View attachment 45048View attachment 45049View attachment 45050View attachment 45051
Diamond plate is the way to go, you should fix this in a minute with an Atoma 140, in two with a 600.
Yes...you fix it top down so you save as much of the original edge as possible.Spine edge though like nemo said right?
Nice work.
I am left wodering- what did you do with the 180 grit sandpaper?
Enter your email address to join: