I made my first handle and this was a particularly sketchy step. Was wondering if there was a source to buy these. Looking for 1/2” and 3/8” in quantities of 10ish
Do you have a sled for your tablesaw/bandsaw? I cut the three inch slot on a full dowel with my hands far away, then rotate the dowel and cut to length. I hope that helps.
OHH... That's fantastic tip. I'd been using a diy jig with a slot and winding the blade up while it was spinning. not very accurate since the blade was down. Do you put the dowel vertically within some guides (in the sled) to make it templated?