SOLD MSicard Cutlery 250mm Stainless-Clad 10V Gyuto (Semi-Custom)

Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

MSicardCutlery

Full-time Knifemaker-Canadian Mazaki
KKF Sponsor
Joined
Feb 28, 2022
Messages
1,861
Reaction score
5,430
Location
Canada
Hello All,

This is a project that has been some time in the making. After much experimentation with other steels, and at least $700 worth of....learning experiences, here it is. It's a thicker than typical blade for me with a good deal of convexity near the edge and good taper. I would classify it as a midweight blade. The cladding is really low in a couple of places, but does not cross the edge anywhere.

20240121_173920.jpg
20240121_163258.jpg

20240121_173928.jpg

20240121_163246.jpg



  • Blade: 250mmx51mm SS clad 10V (~65hrc), 320 grit hand finish
  • Neck Width: 19mm
  • Spine: 3.5mm 17mm back from the heel, 2.57mm at 13cm, .76mm 1cm from the tip
  • Grind: flat to convex, 50/50, zero ground
  • Weight: TBD
  • Relieved choil and spine
  • Edge: .15mm@ 1mm, .32mm@ 2mm, .51mm@ 5mm, .8mm@ 10mm Measured at the midpoint.
I'm offering this blade as a semi custom. Essentially that means the customer as creative freedom with the handle and associated details, and yes I will send it to @KasumiJLA to receive one of his handles if you so desire (he has already agreed 😁 ).

Asking $650 U.S + handle +$25 U.S for shipping with insurance anywhere in North America. International will be in the ballpark of $50-$75 U.S depending on the area. As always, if this blade is purchased in conjunction with another I will happily deduct $25 off of the price of the other blade.

Thanks for taking a look!
 
Last edited:
Back
Top