Hello All,
This is a project that has been some time in the making. After much experimentation with other steels, and at least $700 worth of....learning experiences, here it is. It's a thicker than typical blade for me with a good deal of convexity near the edge and good taper. I would classify it as a midweight blade. The cladding is really low in a couple of places, but does not cross the edge anywhere.
).
Asking $650 U.S + handle +$25 U.S for shipping with insurance anywhere in North America. International will be in the ballpark of $50-$75 U.S depending on the area. As always, if this blade is purchased in conjunction with another I will happily deduct $25 off of the price of the other blade.
Thanks for taking a look!
This is a project that has been some time in the making. After much experimentation with other steels, and at least $700 worth of....learning experiences, here it is. It's a thicker than typical blade for me with a good deal of convexity near the edge and good taper. I would classify it as a midweight blade. The cladding is really low in a couple of places, but does not cross the edge anywhere.
- Blade: 250mmx51mm SS clad 10V (~65hrc), 320 grit hand finish
- Neck Width: 19mm
- Spine: 3.5mm 17mm back from the heel, 2.57mm at 13cm, .76mm 1cm from the tip
- Grind: flat to convex, 50/50, zero ground
- Weight: TBD
- Relieved choil and spine
- Edge: .15mm@ 1mm, .32mm@ 2mm, .51mm@ 5mm, .8mm@ 10mm Measured at the midpoint.
).Asking $650 U.S + handle +$25 U.S for shipping with insurance anywhere in North America. International will be in the ballpark of $50-$75 U.S depending on the area. As always, if this blade is purchased in conjunction with another I will happily deduct $25 off of the price of the other blade.
Thanks for taking a look!
Last edited:
