Corradobrit1
Senior Member
- Joined
- May 2, 2015
- Messages
- 6,910
- Reaction score
- 6,990
289g of sheer Mazaki
B#1 custom from Ikkyu. I gave it a little spa treatment by polishing off the spine and choil to 400 grit - may take it to 800 at some point if I can be bothered.
Unfortunately there was a minor casualty with the handle on install due to some overenthusiastic burning in - tips on the best way to seal these cracks up and get the superglue/epoxy etc to penetrate are welcome. I have some of the tang slot filings ready to mix with the sealant to get an invisible finish.
Beeswax or boardwax combo and hope they don't get worse. I think you'll be fine.